ANALISIS BEBAN KERJA MENTAL PADA OPERATOR AIR TRAFFIC CONTROLLER (ATC) DENGAN METODE SUBJEKTIF DAN OBJEKTIF (STUDI KASUS : AIRNAV BANDAR UDARA XYZ)

Lina Dianati Fathimahhayati

Abstract

An Air Traffic Controller (ATC) operator is required to always concentrate on monitoring navigation, radiation as well as supervising and implementing aircraft guidance. Obviously such work can lead to a mental workload on the worker. Based on these problems, it is necessary to do a research on the analysis of mental workload on the operator ATC at XYZ Airport. Measurement of mental workload can be done in two ways: subjective measurement and objective measurement. Subjective measurements of the mental workload can be done with NASA-TLX method. While the objective measurement can be done by doing the measurement physiologically such as through the heart rate. The results showed that the metal workload of ATY operator of XYZ Airport was in high category and very high base on subjective measurement. Performance level is the dominant factor causing high mental work load perceived by ATC operator. While based on the objective measurement found that the mental workload of ATC operators are in the medium category.

References

Budiman, J., Pujangkoro, Sugih A., dan Anizar, 2015, Analisis Beban Kerja Operator Air Traffic Control bandara XYZ dengan Menggunakan Metode NASA-TLX, Jurnal Teknik Industri FT USU Vol. 3 No. 3, Departemen Teknik Industri Fakultas Teknik USU, Medan.

Hancock, P.A., dan Meshkati, N., 1988, Human Mental Workload, University Of South California, CA.

Hart, S. G., dan Staveland, L. E., 1988, Development of Nasa-Task Load Index (Nasa-Tlx); Result of Empirical and Theoritical Research, Nasa-Ames Research Center. Moffet Field, CA.

Putri, M.R., 2009, Analisis Beban Kerja Mental pada Operator Cetak dengan Menggunakan Metode SWAT (Subjective Workload Assessment technique), ISSN: 2189- 1978, Fakultas Teknologi Industri UAJY, Yogjakarta.

Simanjuntak, R.A., 2010, Analisa Beban Kerja Mental dengan Metode NASA-Task Load Index, Jurnal Teknologi Technoscientia Vol. 3 No.1 ISBN: 1979-8415, Yogyakarta.

Tarwaka, 2011, Ergonomi Industri, Dasar-dasar Pengetahuan Ergonomi dan Aplikasi di Tempat Kerja, Cetakan kedua, UNIPRESS, Surakarta.

Article Metrics

Abstract view: 168 times
Download     : 316   times

Refbacks

  • There are currently no refbacks.