Pengaruh Penggunaan Perturb & Observe pada MPPT terhadap Daya Keluaran Sel Surya

Ernando Rizki Dalimunthe, Freddy Kurniawan, Lasmadi Lasmadi

Submitted : 2019-07-24, Published : 2019-08-30.

Abstract

Optimizing the output power value of a solar cell requires a tracker. The tracking is called the maximum power point tracking (MPPT) which will produce a maximum output power value. Each component in this system is modeled into Simulink. This simulation is designed to optimize the work of solar cells by searching maximum power points using perturb and observe (P&O) algorithms, then duty cycles are output of the algorithms become Buck-Boost Converter inputs as switching so they can produce output power with better output power. Simulation results show that MPPT can increase the average output power on changes in the value of sun irradiation, temperature and load than systems that do not use MPPT. The factor of the average difference in power is 37.82%.

Keywords

Buck-Boost Converter, Duty-cycle, MPPT, Peturb & Observe, Photovoltaics.

Full Text:

PDF

References

Aditiyan, Nora. 2015. Karakteristik Panel Surya Model SR-156P-100 Berdasarkan Intensitas Cahaya Matahari, Skripsi, Jurusan Teknik Elektro, Universitas Lampung, Badar Lampung.

Ananduta, Wayan Wicak. 2011. Simulasi dan Analisis Sistem Maximum Power Point Tracker Berbasis Rangkaian Boost Converter, Skripsi, Fakultas Teknik, UI, Depok,Indonesia.

Dwidayanti, Ranny. 2017. Optimasi Pengisian Daya Baterai Pada Panel Surya Menggunakan Maximum Power Point Tracking (MPPT), Skripsi, Faktulas Teknik, Universitas Lampung, Bandar Lampung.

Esram, T., & Chapman, P. L. (2007). Comparison of photovoltaic array maximum power point tracking techniques. IEEE Transactions on energy conversion, 22(2), 439-449.

Hart, D. W. (1997). Introduction to Power Electronics. New Jersey:Prentice-Hall.

Hegedus,S., & Luque,A. 2003.Handbook of Photovoltaic Science and Engineering. West Sussex: Jhon Wiley & Sons.

Khezzar, A., M. Zereg and R. Khezzar. Comparative Study of Mathematical Methods for Parameters Calculation of Current Voltage Characteristic of Photovoltaic Module. Algeria: Universite Hadj Lakhdar and Universite Mentouri.

Otong, M., & Bajuri, R. M. (2017). Maximum Power Point Tracking (MPPT) Pada Sistem Pembangkit Listrik Tenaga Angin Menggunakan Buck-Boost Converter. Setrum: Sistem Kendali-Tenaga-Elektronika-Telekomunikasi-Komputer, 5(2), 103-110.

Pandiarajan, N., and Ranganath Muthu. Mathematical Modeling of Photovoltaic Module with Simulink. India: Departement of Electrical Engineering SSn College of Engineering Kalavakkan.

Zaana Baskoro. (2017). Analisis Pengaruh Penambahan Sel Surya Untuk Catu Daya Tambahan , Skripsi, Jurusan Teknik Elektro, Sekolah Tinggi Teknologi Adisutjipto, Yogyakarta.

Article Metrics

Abstract view: 747 times
Download     : 755   times

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

Refbacks

  • There are currently no refbacks.